MikroElektronika ETH Click

Overview

ETH Click is an accessory board in mikroBus™ form factor. It features ENC28J60 [2], a 28-pin, 10BASE-T stand alone Ethernet Controller with an on-board MAC & PHY, 8K Bytes of Buffer RAM and SPI serial interface. More information at Eth Click Shield website [1].

Pins Assignment of the Eth Click Shield

Shield Connector Pin

Function

RST#

Ethernet Controller’s Reset

CS#

SPI’s Chip Select

SCK

SPI’s ClocK

SDO

SPI’s Slave Data Output (MISO)

SDI

SPI’s Slave Data Input (MISO)

INT

Ethernet Controller’s Interrupt Output

Requirements

This shield can only be used with a board which provides a configuration for Mikro-BUS connectors and defines node aliases for SPI and GPIO interfaces (see Shields for more details).

Programming

Set --shield mikroe_eth_click when you invoke west build. For example:

# From the root of the zephyr repository
west build -b lpcxpresso55s69 --shield mikroe_eth_click samples/net/dhcpv4_client

References