nPM2100 EK

Overview

The nPM2100 EK lets you test different functions and features of the nPM2100 Power Management Integrated Circuit (PMIC).

Requirements

The nPM2100 EK board is not a direct fit into an Arduino connector. However, the Zephyr shield must be connected to the Arduino shield connectors. That is, you need to connect the I2C lines to the arduino_i2c bus. This allows to use the shield with any host board that supports the Arduino connector.

Usage

To use the shield in any application, build it with the following command:

west build -b your_board --shield npm2100_ek

For a comprehensive sample, refer to nPM2100 EK.