X-NUCLEO-GFX01M2 Display expansion board
Overview
The X-NUCLEO-GFX01M1 and X-NUCLEO-GFX01M2 expansion boards (X-NUCLEO-GFX01Mx) add graphic user interface (GUI) capability to STM32 Nucleo-64 boards. They feature a 2.2” SPI QVGA TFT display as well as a 64-Mbit SPI NOR Flash memory for storing graphic images, texts and texture. The expansion boards also offer a joystick for GUI navigation.
X-NUCLEO-GFX01M2 uses the ST morpho connector and supports up to two SPIs.
The SPI Display is compatible with the ilitek,ili9341 driver and
the SPI FLASH is compatible with the jedec,spi-nor driver.
More information about the board can be found at the X-NUCLEO-GFX01M2 website.
Requirements
This shield can only be used with STM32 Nucleo-64 boards that provide a configuration for ST Morpho connectors. This shield supports up to two SPIs. Two node aliases for the LCD SPI and FLASH SPI are defined in the device tree overlay that must reference the appropriate SPI controllers on the Nucleo board. Consult the X-NUCLEO-GFX01M2 user manual for more information about the SPI pinouts used on your development board:
The SPI FLASH device does not support the Write Protection and Pause features.
For more information about interfacing the MX25L6433F FLASH device and the ILI9341 display controller, see these documents:
Hardware configuration
The default SPI pin control of your development board may not be compatible with the X-NUCLEO-GFX01M2 expansion board. Additionally, it is recommended to configure the SPI pins to high speed and configure DMA channels for the best graphics performance. See boards/nucleo_g071rb.overlay for an example of how to do this.
Samples
The Display and JEDEC SPI-NOR flash samples can be used to test out the expansion boards functionality.
Programming
Set --shield x_nucleo_gfx01m2 when you invoke west build. For example:
# From the root of the zephyr repository
west build -b nucleo_g071rb --shield x_nucleo_gfx01m2 samples/drivers/display/