ArduCam CU450 OV5640 Camera Module
Overview
The ArduCam CU450 OV5640 shield provides the OV5640 image sensor on a 40-pin FFC connector, supporting both the DVP (Digital Video Port) interface and the MIPI CSI-2 interface. It is designed specifically for the Renesas EK-RA8P1 [1] evaluation kit.
Pins assignment
Pin |
Function |
|---|---|
1 |
GND |
2 |
D11 |
3 |
D10 |
4 |
GND |
5 |
D9 / MIPI_CSI2_DL1_P |
6 |
D8 / MIPI_CSI2_DL1_N |
7 |
GND |
8 |
D7 / MIPI_CSI2_CL1_P |
9 |
D6 / MIPI_CSI2_CL1_N |
10 |
GND |
11 |
D5 / MIPI_CSI2_DL0_P |
12 |
D4 / MIPI_CSI2_DL0_N |
13 |
GND |
14 |
D3 |
15 |
D2 |
16 |
GND |
17 |
D1 |
18 |
D0 |
19 |
GND |
20 |
SCL |
21 |
SDA |
22 |
GND |
23 |
VSYNC |
24 |
HSYNC |
25 |
RESET |
26 |
XCLK |
27 |
PCLK |
28 |
INT |
29 |
GND |
30 |
GND |
31 |
3V3 |
32 |
GND |
33 |
GND |
34 |
3V3 |
35 |
3V3 |
36 |
3V3 |
37 |
GND |
38 |
GND |
39 |
3V3 |
40 |
GND |
Requirements
This shield requires a board with a 40-pin FFC connector. The Renesas EK-RA8P1 evaluation kit is fully supported.
Note
While the CU450 OV5640 module and connector provide both DVP and MIPI CSI-2 interfaces, only the DVP interface is currently supported on Renesas RA SoCs. MIPI CSI-2 is not yet supported on this platform.
Programming
Set --shield arducam_cu450_ov5640_dvp when you invoke west build. For example:
# From the root of the zephyr repository
west build -b ek_ra8p1/r7ka8p1kflcac/cm85 --shield arducam_cu450_ov5640_dvp samples/drivers/video/capture