Quadrature Decoder Sensor

Browse source code on GitHub

Overview

This sample reads the value of the counter which has been configured in quadrature decoder mode.

It requires:

• an external mechanical encoder

• pin to be properly configured in the device tree

Building and Running

In order to run this sample you need to:

• enable the quadrature decoder device in your board’s DT file or board overlay

• add a new alias property named qdec0 and make it point to the decoder device you just enabled

For example, here’s how the overlay file of an STM32F401 board looks like when using decoder from TIM3 through pins PA6 and PA7:

/ {
    aliases {
        qdec0 = &qdec;
    };
};

&timers3 {
    status = "okay";

    qdec: qdec {
        status = "okay";
        pinctrl-0 = <&tim3_ch1_pa6 &tim3_ch2_pa7>;
        pinctrl-names = "default";
        st,input-polarity-inverted;
        st,input-filter-level = <FDIV32_N8>;
        st,counts-per-revolution = <16>;
    };
};

Sample Output

Once the MCU is started it prints the counter value every second on the console

Quadrature decoder sensor test
Position = 0 degrees
Position = 15 degrees
Position = 30 degrees
...

Of course the read value changes once the user manually rotates the mechanical encoder.

Note

The reported increment/decrement can be larger/smaller than the one shown in the above example. This depends on the mechanical encoder being used and st,counts-per-revolution value.

See also

Sensor Interface