RA2A1 Evaluation Kit

Overview

The EK-RA2A1 is an evaluation kit for Renesas RA2A1 Microcontroller Group.

Renesas RA2A1 Microcontroller Group has following features

  • 48MHz, Arm Cortex-M23 core

  • 256kB Code Flash, 8kB Data Flash, 32kB SRAM

  • USB 2.0 Full-Sppeed

  • SCI x 3

  • SPI x 2

  • I2C x 2

  • CAN x 1

  • 16-bit A/D Converter

  • 24-bit Sigma-Delta A/D Converter

  • 12-bit D/A Converter

  • 8-bit D/A Converter x 2

  • High-Speed Analog Comparator

  • Low-Power Analog Comparator

  • OPAMP x 3

  • Temperature Sensor

  • General PWM Timer 32-bit x 1

  • General PWM Timer 16-bit x 6

  • Low Power Asynchronous General-Purpose Timer x 2

  • Watchdog Timer

  • 49 Input/Output pins

RA2A1 Evaluation Kit

EK-RA2A1 Board Functional Area Definitions (Credit: Renesas Electronics Corporation)

Hardware

Detail Hardware feature for the RA2A1 MCU group can be found at RA2A1 Group User’s Manual Hardware [1]

RA2A1 MCU group feature

RA2A1 Block diagram (Credit: Renesas Electronics Corporation)

Detail Hardware feature for the EK-RA2A1 MCU can be found at EK-RA2A1 - User’s Manual [1]

EK-RA2A1 has following features.

  • Native pin access through 4x 40-pin male headers

  • MCU current measurement points

  • SEGGER J-Link on-board programmer and debugger

  • Two Digilent Pmod (SPI and UART)

  • User LED

  • Mechanical user button

  • Capacitive user button

Supported Features

The Renesas EK-RA2A1 board configuration supports the following hardware features:

Interface

Controller

Driver/components

PINCTRL

on-chip

pinctrl

CLOCK

on-chip

clock_control

GPIO

on-chip

gpio

UART

on-chip

uart

The default configuration can be found in boards/renesas/ek_ra2a1/ek_ra2a1_defconfig

Programming and debugging

Building & Flashing

You can build and flash an application with onboard J-Link debug adapter. Building an Application and Run an Application for more details.

Here is an example for building and flashing the Blinky application.

# From the root of the zephyr repository
west build -b ek_ra2a1 samples/basic/blinky
west flash

Debugging

Debugging also can be done with onboard J-Link debug adapter. The following command is debugging the Blinky application. Also, see the instructions specific to the debug server that you use.

# From the root of the zephyr repository
west build -b ek_ra2a1 samples/basic/blinky
west debug

References