renesas,smartbond-regulator

Vendor: Renesas Electronics Corporation

Note

An implementation of a driver matching this compatible is available in drivers/regulator/regulator_da1469x.c.

Description

Renesas Smartbond(tm) LDO and DCDC regulators

Properties

Top level properties

No top-level properties.

Child node properties

Name

Type

Details

renesas,regulator-v30-ref-bandgap

boolean

 
Selects reference source for V30 LDO to Bandgap output.

renesas,regulator-v30-clamp

boolean

 
Enables clamp that can supply V30 from VBAT.

renesas,regulator-v30-vbus

boolean

 
Allow V30 to be powered from VBUS.

renesas,regulator-v30-vbat

boolean

 
Allow V30 to be powered from VBAT.

renesas,regulator-dcdc-vbat-high

boolean

 
Enable DCDC in high battery voltage mode.

renesas,regulator-dcdc-vbat-low

boolean

 
Enable DCDC in low battery voltage mode.

renesas,regulator-sleep-ldo

boolean

 
Enable LDO in sleep mode.

regulator-init-microvolt

int

 
Voltage set during initialisation

regulator-max-microamp

int

 
largest current consumers may set

regulator-always-on

boolean

 
boolean, regulator should never be disabled

regulator-boot-on

boolean

 
bootloader/firmware enabled regulator.
It's expected that this regulator was left on by the bootloader.
If the bootloader didn't leave it on then OS should turn it on
at boot but shouldn't prevent it from being turned off later.
This property is intended to only be used for regulators where
software cannot read the state of the regulator.

regulator-initial-mode

int

 
Initial operating mode. The set of possible operating modes depends on the
capabilities of every hardware so each device binding documentation
explains which values the regulator supports.