ti,lp5562 (on i2c bus)

Vendor: Texas Instruments

Description

TI LP5562 LED

Properties

Properties not inherited from the base binding file.

Name

Type

Details

supply-gpios

phandle-array

GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.

red-output-current

int

Output current of red channel in 0.1 mA (0-25.5 mA). Default value is the power-on default. Valid range = 0 - 255

Default value: 175

green-output-current

int

Output current of green channel in 0.1 mA (0-25.5 mA) Default value is the power-on default. Valid range = 0 - 255

Default value: 175

blue-output-current

int

Output current of blue channel in 0.1 mA (0-25.5 mA) Default value is the power-on default. Valid range = 0 - 255

Default value: 175

white-output-current

int

Output current of white channel in 0.1 mA (0-25.5 mA) Default value is the power-on default. Valid range = 0 - 255

Default value: 175

enable-gpios

phandle-array

GPIO to enable LP5562 (both Charge-pump and Digital Communications interface).
If not provided, user must ensure enable pin is already asserted externally (e.g:
pull-up resistor).